LCD Monitor Fujitsu Siemens Scenicview A17-2 turns off

Today we repaired a couple of LCD Monitors, Fujitsu Siemens Scenicview A17-2 that came into our shop from a regular customer. They all had a described fault by the customer: Turns on and then turns off after a few seconds, normally two seconds. Both LCD´s have the same problem.

LCD Monitor Fujitsu Siemens Scenicview Rearview A17-2
LCD Monitor Fujitsu Siemens Scenicview Rearview A17-2

So as usual, first thing to do, besides testing it for yourself and confirming the fault. Would be to open it up and take a look inside. Always Use extreme caution when managing the internal boards, because even when powered off, that main capacitor can bite pretty badly. I personally use this little (4K7 – 5% – Ceramic Resistor)

4K7 Ceramic Resistor
Discharge Capacitors With 4K7 Ceramic Resistor

So now we took a look at the power board and we were expecting a lot of Blown Caps, but it appeared that there were only two bad caps, as shown below.

Power Board P/N: 3bs0101313gp
Power Board View with two blown caps – P/N: 3bs0101313gp

We tested the two bad Capacitors with our Peak Atlas ERS+ ESR70, and just as expected it showed “Leaky” and a High ESR Value.

Peak Atlas ERS+ ESR70
Blown Capacitor tested by Peak Atlas ERS+ ESR70

To Resume up the repair, all we had to do was to desolder those two 1000Uf 25V Capacitor with two new 1000Uf 35V Caps… The problem was the same for all of these LCD´s that we received… So after a few hours testing these old Fujitsu Scenicview A17-2 everything was fine and dandy.

Tip of the Day: When testing caps, we always test them removed from the board, even though the ESR70 is made to test capacitors “in-circuit” , we find readings to be much more accurate when they are no longer soldered to the board.

If you found this post helpful in anyway and you would like to support Fixepedia for some future content. We would extremely appreciate it if you are thinking of buying a Peak Atlas ESR70 for yourself or if you would like to check out the specs, then check out our Affiliate link with no extra cost to you: Peak Atlas ESR+ ESR70

Thanks for reading.

2 thoughts on “LCD Monitor Fujitsu Siemens Scenicview A17-2 turns off

    • Fixepedia Post authorReply

      Hi Chris,
      Thanks for your feedback 🙂 it helps a lot and boosts motivation 😉
      Cheers and happy repairs!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.